Measuring Process

Once switched on, the measuring tool is in the length measurement function.

Once the measuring tool has been switched on, the rear edge of the measuring tool is selected as the reference level for measurement.

You can change the reference level see Selecting the Reference Level.

  1. Apply the measuring tool to the point at which you want to start the measurement (e.g. wall).
  1. If you have switched on the measuring tool using the (5)  button, briefly press the (2)  button to switch the laser on.
  1. Press the (2)  button to start the measurement.

Then the laser beam is switched off. For a further measurement, repeat this process.

The measured value typically appears within 0.5 seconds and after no more than approx. 4 seconds. The duration of the measurement depends on the distance, the lighting conditions and the reflective properties of the target surface. Upon completion of the measurement, the laser beam is automatically switched off.

The measuring tool must not be moved during a measurement (with the exception of the continuous measurement and grade measurement functions). Therefore, place the measuring tool, as far as this is possible, against or on a firm stop or supporting surface.
The reception lens (14) and the laser beam output (15) must not be covered during the measuring process.