Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
Switching on/off
- Make sure that you are able to press the On/Off switch without releasing the handle.
To switch on the power tool, press the on/off switch (3).
Press the locking mechanism (2) to lock the on/off switch (3) in this position.
To switch off the power tool, release the on/off switch (3). If the on/off switch (3) is locked, press the switch first and then release it.
Speed preselection
You can preselect the required speed using the thumbwheel for speed preselection (1), even during operation. The required speed depends on the material and the working conditions; it can be ascertained through practical tests.
Thumbwheel position | No-load speed (min-1) |
|---|---|
1 | 2500 |
2 | 3000 |
3 | 3500 |
4 | 4000 |
5 | 4500 |
6 | 5000 |