Starting Operation
Switching on/off
To start the power tool, press the on/off switch (1).
Press the locking mechanism (2) to lock the on/off switch (1) in this position.
To switch off the power tool, release the on/off switch (1); or, if the switch is locked, briefly press the on/off switch (1) and then release it.
- Always check polishing tools before using them. The polishing tools must be fitted properly and be able to move freely. Carry out a test run for at least one minute with no load. Do not use polishing tools that are damaged, run untrue or vibrate during use. Damaged polishing tools can burst apart and cause injuries.
LED Displays
The following table explains the possible LED displays (5).
Colour | State | Meaning/cause | Solution |
|---|---|---|---|
White | Continuous light | Speed preselection | |
Green | Continuous light | Battery charged | |
Yellow | Continuous light | Battery almost empty see Battery charge indicator | Replace or charge battery soon |
Flashing light | Critical temperature has been reached (motor, electronics, battery) | Run the power tool at no load and allow it to cool down | |
Red | Continuous light | Battery empty see Battery charge indicator | Replace or charge battery |
Flashing light | Power tool is overheated and will switch off | Leave the power tool to cool down and switch it on again | |
Power tool is jammed and will switch off | Rectify the blockage and switch the power tool on again |