Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

To start, press the green "on" button (57).

Press the safety flap (16).

The on/off switch acts as a zero-voltage switch that prevents the power tool from starting up again following a power outage (e.g. if the mains plug is removed during operation).
To restart the power tool following a power outage, press the green "on" button (57) again.

To protect against unauthorised use, you can lock the safety flap of the on/off switch (16) with a padlock.

Slide the viewing window (58) all the way up and gently press on the safety flap.
Fit a padlock through the two eyelets in the viewing window and the eyelet in the base plate of the on/off switch.

Start-up

Switching on (see figure G1)

Switching off (see figure G2)

Power outage

Protection against unauthorised use (see figure G3)