Product features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Scale for spacing between saw blade and parallel guide |
(2) | Angle guide |
(3) | Protective cover |
(4) | Riving knife |
(5) | Parallel guide |
(6) | Saw table expansion |
(7) | Angle guide storage compartment |
(8) | Assembly holes |
(9) | Ring spanner (24 mm; 23 mm) |
(10) | Hex key (5 mm) |
(11) | Bracket for storing the protective cover |
(12) | Push stick |
(13) | Clamping handle for saw table expansion |
(14) | Hand wheel |
(15) | Crank for raising and lowering the saw blade |
(16) | Safety flap for the on/off switch |
(17) | Stop for 45° bevel angle (vertical) |
(18) | Locking lever for setting the bevel angle |
(19) | Scale for bevel angles (vertical) |
(20) | Stop for 0° bevel angle (vertical) |
(21) | Saw table |
(22) | Adjusting screw for adjusting the clamping force of the parallel guide |
(23) | Table insert |
(24) | Saw blade |
(25) | Guide groove for parallel guide |
(26) | Cable holder |
(27) | Carrying handle |
(28) | Guide groove for angle guide |
(29) | Dust extraction adapter |
(30) | V guide groove on the saw table for the parallel guide |
(31) | Base plate |
(32) | Locking screw for base grid |
(33) | Clamping lever/clamp markings |
(34) | Clamping lever for riving knife |
(35) | Positioning pins for riving knife |
(36) | Table insert locking screw |
(37) | Clamping lever for protective cover |
(38) | Guide pin for protective cover |
(39) | Clamping handle for parallel guide |
(40) | V guide for parallel guide |
(41) | Additional parallel guide |
(42) | "Additional parallel guide" fastening set |
(43) | Guide rail for angle guide |
(44) | Lower saw blade cover |
(45) | Tab for lower saw blade cover |
(46) | Gripping hole for lifting the table insert |
(47) | Clamping nut |
(48) | Spindle locking lever |
(49) | Clamping flange |
(50) | Mounting flange |
(51) | Tool spindle |
(52) | Angle indicator (vertical) |
(53) | Locking knob for all mitre angles (horizontal) |
(54) | Angle indicator on the angle guide |
(55) | Magnifying glass |
(56) | Saw table spacing indicator |
(57) | On button |
(58) | Viewing window |
(59) | Cross-head screw for setting the 0° stop |
(60) | Screw for bevel angle indicator (vertical) |
(61) | Cross-head screw for setting the 45° stop |
(62) | Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade |
(63) | Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade |
(64) | Screw for saw table spacing indicator |
(65) | Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide |
(66) | Screw for parallel guide spacing indicator |
(67) | Adjusting screws for table insert |
(68) | Push stick storage compartment |
(69) | Hex key storage compartment |
(70) | Ring spanner storage compartment |